Tire Notes

Gear Ratio Calculator for a Tire Size Change

Find the axle ratio that would restore the original gearing after a tire diameter change. Check a candidate ratio against your old cruising RPM.

Inputs

Your result

Effective axle ratio with original gears on new tires
3.086 :1
Axle ratio that restores original gearing
4.2 :1
Engine speed with the candidate axle ratio
1,890.04 rpm
Candidate gearing change from original
-2.381 %

Saved results stay in this browser.

Saved calculations and CSV

How the calculation works

Multiply the original axle ratio by the new diameter divided by the original diameter to get the ratio that restores the original RPM at the same road speed and transmission gear. Estimate wheel RPM by dividing road speed in inches per minute by the tire circumference, then multiply by both gear ratios.

From 30-inch to 35-inch tires

A 3.60 axle ratio on the 30-inch set calls for a 4.20 ratio on the 35-inch set to match the original RPM. A candidate of 4.10 gives about 2.38% lower engine RPM than the original setup in the same transmission gear.

Pick a transmission gear for the RPM comparison

Use 1.00 for direct drive or enter the listed ratio of your chosen overdrive gear. The estimate assumes the chosen gear stays engaged and the torque converter, if present, is locked. Use diameters measured in the same way for both tires.

Back to Tire Notes

Dana Spicer engine RPM calculator

Related calculators